|
|
|
|
| Component roll-in cases are most often designed as an E4 style case with hinged front opening door. The front door (lid) is supported with a 5th caster to provide support and stability when component is rolling up the ramp. The case shown here was designed and built for a major manufacturer of graphic imaging devices for the photographic industry. Their tradeshow and training schedule demanded rapid set-up and tear down of their bulky and heavy rolling devices. Their extremely expensive components demanded ULTRA STAR premium 1/2" construction cases. After contacting other case manufacturers, they contacted Star Case; the only company with the engineering strength and know-how to tackle the project. This case has successfully transported an 800 pound device over 50 times on international shipments and is no where near the end of its serviceable life. After careful discussions with our client, we intelligently responded to the following criteria for this project: |
|
The Result: The case shown here is ideally suited for field work or portable trade show transport. Variations to consider are an increase or decrease in the number of extra component compartments or a double-length hinged ramp that provides lower incline for even larger and heavier components. |
|
| NOTE: This is but one of literally hundreds of similar designs Star Case has successfully designed and built for time and dollar conscious clients. Visit our Custom Design Quote Form or call today for your custom variation of specific requirements. | |
|
Star Case Manufacturing
Co., Inc.
The data contained in this document is the
property of Star Case Manufacturing Co., Inc. and is not to be
reproduced or distributed |
Case
contents must load and unload easily by one person in less than 10 minutes.
